You are here:
News
News
Calculation For Intake runner length? 2010-12-28
I'm currently working on an Individual Throttle body intake for my Car. I was wondering what to use to calculate the optimum runner length for the intake, before the throttle bodies. Better if there w
Harley Reversion Problem 2010-12-28
I found this forum through Google and was blown away at the knowledge I saw here. I found another reversion thread on here and did find some information useful but his problem was a little different t
stress concentration and fatigue 2010-12-27
Do i have to reduce this stresses with something like NEUBER´s rule when plasticity occurs (above yield)and if the stresses are not beyond yield can i thrust them ? or can i just fillet the notch ?
ext/ret a cylinder without a DVC 2010-12-27
I have to extend and retract a cylinder (and i must be able to control it) with out the use of a DVC this can be done using 1, 2 or 4 componants.
FMS Drifting Problem 2010-12-27
We have a Mazak FMS system supporting three 4K lasers MKII 510's. We have encountered a problem with the sheet loader side of the Traverser, it has a drifting problem after it has loaded the sheet and
Preventive maintenance of Shutdown Valve (SDV) 2010-12-24
Shutdown Valve (SDV) are used for isolation of process system in case of emergency.
i) Should a preventive measure (PM) apply on SDV ?
Multiple fire risers and multiple FDC's 2010-12-24
We recently installed two separate risers covering several different areas of the building. Each is covered by its own FDC located on the same side of the building.
Sump Pump Pit Woes 2010-12-24
We moved in to our new home 20 months ago. We have a sump pump in our basement in an 18” x 24” polyethylene pit.
