We are talking about a thick part, made of nylon with glass fiber. Once injected, in the surface it seems to be well compacted but in the interior there are "bubbles".

I'm looking to run 2 large (600kW) centrifugal pumps in parallel (duty / assist). One of the pumps is new the other is 50 years old but has similar head / flow characteristic although lower efficiency

I drive a 2003 Tiburon 2.7, turboed with a Garrett GT30R turbo, with a 38mm TiAL wastegate.

I'm currently deployed to Iraq with the US Army and I'm working on hooking up an air compressor. I am not an electrician, but I have a little knowledge.

I'm currently working on an oil and gas subsea project whereby the client plans to tie-back a two-well marginal field (to a common manifold, and then) to their host facility, which is some 8 miles a

I am installing a small plunger pump (CAT 230 with variable speed drive) to pump water at low flowrates into a pressurised steam line in our R&D test facilities.

As mentioned in another thread, I too need the "Idiot's Guide to HVAC" as this is not my discipline. I am an instrumentation and controls engineer trying to understand the impact of a client changee

I appreciate if anyone can tell me the common causes for a Dry Gas seal failure in a Cryogenic Service. A John Crane Type 28 VL is installed on a (newly commisioned )Ethylene pump.